meter per second squared to gal
Convert meter per second squared (m/s²) to gal (Gal). Use an editable acceleration converter, conversion formula, and reference table.
1 m/s² = 100 Gal
Conversion formula
One meter per second squared equals 100 gal. Multiply your value in meter per second squared by this factor to get gal. For the reverse conversion, divide by the same factor.
Worked example
To convert 5 meter per second squared:5 × 100 = 500 Gal
Conversion table
| meter per second squared (m/s²) | gal (Gal) |
|---|---|
| 0.01 | 1 |
| 0.1 | 10 |
| 1 | 100 |
| 2 | 200 |
| 5 | 500 |
| 10 | 1,000 |
| 25 | 2,500 |
| 50 | 5,000 |
| 100 | 10,000 |
| 1000 | 100,000 |
About these measurements
Acceleration is the rate of velocity change.
The base reference used here is the meter per second squared. One meter per second squared is 1 base units; one gal is 0.01 base units.
Important distinctions
Compound units must match the quantity and dimension. Temperature intervals use size factors rather than temperature offsets. Calorie and BTU entries use the explicit definitions shown.
Precision
The converter uses stored conversion factors and floating-point arithmetic. Results display up to ten significant digits, switching to scientific notation for very small or large values. Keep the precision of your original measurement when reporting results.
Common questions
How do I convert m/s² to Gal?
Multiply the quantity in m/s² by 100. You can also type the value into the converter above.
Can I reverse the conversion?
Yes. Use the swap button or open the gal to meter per second squared converter.
Reference
NIST Guide to the SI — conversion factors and prefix conventions. SI prefixes scale units by powers of ten; the dimension-specific notes above describe the assumptions used on this page.
