dyne per centimeter to pound force per inch
Convert dyne per centimeter (dyn/cm) to pound force per inch (lbf/in). Use an editable surface tension converter, conversion formula, and reference table.
1 dyn/cm = 0.000005710147155 lbf/in
Conversion formula
One dyne per centimeter equals 0.000005710147155 pound force per inch. Multiply your value in dyne per centimeter by this factor to get pound force per inch. For the reverse conversion, divide by the same factor.
Worked example
To convert 5 dyne per centimeter:5 × 0.000005710147155 = 0.00002855073577 lbf/in
Conversion table
| dyne per centimeter (dyn/cm) | pound force per inch (lbf/in) |
|---|---|
| 0.01 | 5.71014715e-8 |
| 0.1 | 5.71014715e-7 |
| 1 | 0.000005710147155 |
| 2 | 0.00001142029431 |
| 5 | 0.00002855073577 |
| 10 | 0.00005710147155 |
| 25 | 0.0001427536789 |
| 50 | 0.0002855073577 |
| 100 | 0.0005710147155 |
| 1000 | 0.005710147155 |
About these measurements
Surface tension describes force per unit length along a liquid interface.
The base reference used here is the newton per meter. One dyne per centimeter is 0.001 base units; one pound force per inch is 175.1268352 base units.
Important distinctions
Compound units must match the quantity and dimension. Temperature intervals use size factors rather than temperature offsets. Calorie and BTU entries use the explicit definitions shown.
Precision
The converter uses stored conversion factors and floating-point arithmetic. Results display up to ten significant digits, switching to scientific notation for very small or large values. Keep the precision of your original measurement when reporting results.
Common questions
How do I convert dyn/cm to lbf/in?
Multiply the quantity in dyn/cm by 0.000005710147155. You can also type the value into the converter above.
Can I reverse the conversion?
Yes. Use the swap button or open the pound force per inch to dyne per centimeter converter.
Reference
NIST Guide to the SI — conversion factors and prefix conventions. SI prefixes scale units by powers of ten; the dimension-specific notes above describe the assumptions used on this page.
